Software

10 posts Published between 09/2026 – 10/2026

Tutorials Software #esp32 #debugging #serial-monitor #logs

Serial monitor and debugging on the ESP32: stop guessing

How to actually debug on the ESP32: a properly configured serial monitor, leveled logs, brownout, watchdog, panic backtraces and when to use JTAG.

07/10/2026 3 min read Intermediate

Software Tools #esp32 #esp-idf #vscode #jtag

VS Code + ESP-IDF: the official environment with JTAG included

How to set up VS Code with the official ESP-IDF extension: install, create a project, menuconfig, build, flash, monitor and debug over JTAG.

04/10/2026 2 min read Advanced

Software Tools #esp32 #platformio #vscode #ide

VS Code + PlatformIO for ESP32: the environment I use every day

How to get VS Code + PlatformIO ready for the ESP32: installation, platformio.ini, upload and monitor, per-project libraries and debugging.

03/10/2026 2 min read Intermediate

Software Tools #esp32 #arduino #ide #drivers

Arduino IDE 2.x for ESP32: step-by-step setup (and the usual errors)

How to install and configure Arduino IDE 2.x for the ESP32: board URLs, board selection, CH340/CP2102 drivers, uploading and the serial monitor.

02/10/2026 2 min read Beginner

Software Tools #esp32 #ide #vscode #arduino

Which IDE should you use for the ESP32? Arduino IDE, VS Code and friends

A comparison of environments for programming the ESP32: Arduino IDE 2.x, VS Code with PlatformIO, VS Code with ESP-IDF, Thonny and CLion. Which one to pick per framework.

01/10/2026 3 min read Beginner

Software #esp32 #rust #esp-idf #embassy

Rust on the ESP32: esp-idf-hal, esp-hal and embassy without drama

How to program the ESP32 in Rust: the two paths (esp-idf-hal with std and esp-hal no_std), the espup toolchain, examples and when it is worth it.

30/09/2026 2 min read Advanced

Page 1 of 2

Other categories

Connectivity 1 Fundamentals 14 Hardware 9 Tools 4 Tutorials 3